favorite
favorite
hide
unhide
flag

Posted

print

Project - $1,500 (Norwich)

Project 1 thumbnailProject 2 thumbnailProject 3 thumbnailProject 4 thumbnailProject 5 thumbnailProject 6 thumbnailProject 7 thumbnailProject 8 thumbnailProject 9 thumbnailProject 10 thumbnailProject 11 thumbnail
Tracked buggy built on an old Craftsman rider frame. I never got the steering quite right. I tried belt tensioning for steering clutches, then double pulleys, now it has 2 (expensive) manual gokart / mini bike clutches mounted. Chain driven to rear wilh 3 jackshafts and geared down aprox 12-1. Has a BUILT 212 Predator thats somewhere between 12-20 hp, never put on a dyno. Has 1 hour on it after breakin. Comet 40 series clone variable speed engine clutch to take the higher hp with 1" adaptor to fit the Predator 3/4" shaft. Tracks are new surplus that fit Toro Dingo, are aprox 48" long when mounted. All 4 sprockets were made in my shop, drive on the lugs inside track. Has hydraulic disc brakes each side in rear. I kept track of everything that went into motor (picture of sheet included), and most of the designs that went into the project.
Health concerns are keeping me from finishing, though I'd like to. The fix may be to widen tha tracks out farther away from the frame, but I'm not going to be able to finish it. Prices are firm, I have a ton of money in it. $1500 as is, or $1000 minus the engine and engine clutch. Not selling motor separately. NO TRADES. Will include box of single and double pulleys, idlers, and tensioning parts.
Leave your phone number through CL email, and I'll call as soon as I see it.

PTV, personal tracked vehicle, crawler, dozer, ATV, Husqvarna, Briggs and Stratton, Tecumseh, dune buggy, Toro, Kubota, Murray, go cart, gocart, doodlebug, bobcat, mini excavator

post id: 7756546775

posted:

best of [?]

loading
reading
writing
saving
searching